Command Syntax for BIRD configuration
santiago at crfreenet.org
Mon Jan 25 10:16:13 CET 2010
On Mon, Jan 25, 2010 at 03:51:42PM +0800, Affandi INDRAJI wrote:
> I tried to find out the documentation of the Command Syntax for BIRD
> configuration, for example in cisco if we want to set the community for
> certain peer we can configure it like this:
> route-map test-in permit 10
> set community 17819:64901 additive
> neighbor 10.1.1.1 route-map test-in in
> I try to figure out base on the documentation available in
> http://bird.network.cz/ but I can't find any (or maybe I miss it out).
Here is the documentation of BIRD commands:
But these commands are not used for configuration, but mostly for examination
of the state of protocol sessions and routing tables.
BIRD is configured by editing a config file, not by a command line.
The syntax of the config file is here:
For example, adding the community for certain peer can be done using filters,
as it is shown in the last link.
Elen sila lumenn' omentielvo
Ondrej 'SanTiago' Zajicek (email: santiago at crfreenet.org)
OpenPGP encrypted e-mails preferred (KeyID 0x11DEADC3, wwwkeys.pgp.net)
"To err is human -- to blame it on a computer is even more so."
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 197 bytes
Desc: Digital signature
More information about the Bird-users