Hi again, Now that OSPF stub networks work on loopback and dummy interfaces work again, I've run across another Issue, OSPFv3 refuses to recognize any networks on a vrf interface, even with a ipv6-ll adress added. I'm not entirely sure if I'm even supposed to add addresses to the vrf interface, but as far as I know, I can just use the vrf interface for the router ip (normally the job of loopback). BIRD v2.0.4-10-g6ff81197 ready. bird> show interfaces lo up (index=1)         MultiAccess AdminUp LinkUp Loopback Ignored MTU=65536         127.0.0.1/8 (Preferred, scope host)         10.30.0.54/32 (scope site)         ::1/128 (Preferred, scope host)         fe80::1/128 (Preferred, scope link) enp1s0 up (index=2)         MultiAccess Broadcast Multicast AdminUp LinkUp MTU=1500         10.30.0.54/24 (Preferred, scope site)         fe80::5054:ff:fe01:ea75/64 (Preferred, scope link)         fdde:e540:e627:0:5054:ff:fe01:ea75/64 (Preferred, scope site) enp7s0 up (index=3)         MultiAccess Broadcast Multicast AdminUp LinkUp MTU=1500         169.254.169.2/32 (Preferred, opposite 169.254.169.254, scope univ)         fe80::5054:ff:fe15:9119/64 (Preferred, scope link) dummy0 down (index=6)         MultiAccess Broadcast Multicast AdminDown LinkDown MTU=1500 dn42 up (index=8)         MultiAccess AdminUp LinkUp MTU=65536         172.20.18.226/32 (Preferred, scope site)         172.20.10.0/24 (scope site)         fe80::1111:1111:1111:1111/64 (Preferred, scope link) enp8s0 up (index=4 master=dn42)         MultiAccess Broadcast Multicast AdminUp LinkUp MTU=1500         169.254.254.1/32 (Preferred, opposite 169.254.254.2, scope univ)         fe80::5054:ff:feec:af5/64 (Preferred, scope link) bird> show ospf interface ospf1 ospf1: Not a protocol bird> show ospf interface dn42_ospf_ip4 dn42_ospf_ip4: Interface enp8s0 (IID 64)         Type: ptp         Area: 0.0.0.0 (0)         State: PtP         Priority: 1         Cost: 10         ECMP weight: 1         Hello timer: 10         Wait timer: 40         Dead timer: 40         Retransmit timer: 5 bird> important part of bird.conf protocol ospf v3 dn42_ospf_ip4 {     vrf "dn42";     ipv4 {         table dn42     };     area 0.0.0.0 {         interface "dn42" {             stub yes;                };     }; };