Hi, I set up bird and bird6 to replace my quagga-setup. I get full-tables for IPv4 and IPv6 but bird fails to import most of them. Example: Quagga needs a maximum of 10 seconds to import 500k routes into main table where bird needs 20 minutes to reach this state: bgp_peer1 BGP master up 19:07:10 Established Preference: 100 Input filter: ACCEPT Output filter: (unnamed) Routes: 226754 imported, 1 exported, 226754 preferred Route change stats: received rejected filtered ignored accepted Import updates: 226754 0 0 0 226754 Import withdraws: 0 0 --- 0 0 Export updates: 226755 226754 0 --- 1 Export withdraws: 0 --- --- --- 0 BGP state: Established Neighbor address: X Neighbor AS: X Neighbor ID: X Neighbor caps: refresh restart-aware AS4 Session: external AS4 Source address: X Hold timer: 72/90 Keepalive timer: 10/30 My config (AS and Net anonymized): # Set local AS define myas=13456; protocol device { scan time 10; } protocol kernel { import all; export all; persist; scan time 15; } protocol static static_bgp { import all; # My net - Set prefixes to be announced (anonymized) route 1.1.1.0/24 reject; } protocol bgp bgp_peer1 { import all; export where proto = "static_bgp"; interpret communities no; missing lladdr ignore; local as myas; neighbor 8.8.8.8 as 1234; password "xxxxxxxxxxxx"; } ------------------ I don't see what is going wrong. Also I don't get why routes are re-exported to bgp_peer1 while "static_bgp" only lists one network. Any ideas? Thanks, Kevin