I'm trying to use ECMP, but without success, I'll leave my conf below, does anyone know where I'm going wrong? Q. I have two routers announcing the default route for this "client". conf: log syslog all; # Override router ID router id 10.192.0.2; # Turn on global debugging of all protocols debug protocols all; protocol direct { interface "-eth*", "*"; # Restrict network interfaces it works with } filter kernel_export { print "filter_name: ", "kernel_export", " protocol: ", proto, " net: ", net, " krt_metric: ", krt_metric; if net = 0.0.0.0/0 then { krt_metric = 100; } accept; } protocol kernel { learn; # Learn all alien routes from the kernel persist; # Don't remove routes on bird shutdown scan time 20; # Scan kernel routing table every 20 seconds import all; # Default is import all export filter kernel_export; # Default is export none } protocol device { scan time 10; # Scan interfaces every 10 seconds } protocol static { disabled; # Disable by default } filter ospf_import { print "router_id: ", ospf_router_id, " net: ", net, " ospf_metric1: ", ospf_metric1 ; if net = 0.0.0.0/0 then { ospf_metric1 = 1000; } accept; } protocol ospf { ecmp yes; import filter ospf_import; export all; tick 1; rfc1583compat yes; area 0.0.0.0 { networks { 10.192.0.0/29; }; interface "eth1" { type broadcast; authentication none; }; }; } output of 'show ospf state' in this host: area 0.0.0.0 router 10.192.0.1 distance 10 network 10.192.0.0/29 metric 10 external 0.0.0.0/0 metric2 10000 router 10.192.0.2 distance 0 network 10.192.0.0/29 metric 10 external 100.126.0.44/32 metric2 10000 router 10.192.0.3 distance 10 network 10.192.0.0/29 metric 10 external 0.0.0.0/0 metric2 10000 network 10.192.0.0/29 dr 10.192.0.3 distance 10 router 10.192.0.3 router 10.192.0.2 router 10.192.0.1 -- André Carlim StubNetwork