Hello, On a BIRD 3 route reflector the main thread runs at 100% CPU all the time, and almost all of it is in msl_cleanup(). Setup: - ~2,700 BGP sessions (iBGP rr clients and eBGP multihop) - threads 20 on a 32 vCPU VM; no IGP, only BGP and static reject routes - worker threads at 5-12% each Measurements: - BIRD 3.3.2, process up 2h19m: total CPU 15h26m. perf on the main thread: 94% at a single address in msl_cleanup_full_heads() (lib/mslab.c:723, the walk over full_heads). - BIRD 3.4.0, about 10 minutes after a restart, perf on the main thread: 98.7% in msl_cleanup (57k samples in 15 s). - In 8 of our 12 crash cores, the main thread was inside msl_cleanup(). Two cores are aborts on asserts in that code: lib/mslab.c:731 (ASSERT_DIE(num_full < s->objs_per_slab)) and lib/event.c:332. How we read the code: msl_free() sends the cleanup event whenever a page leaves the full state (or its last object is freed), and every msl_cleanup_full_heads() run walks the whole full_heads list. With a large attribute cache and constant churn from thousands of sessions, the cleanup is rescheduled all the time and each run is O(number of full pages). We reduced our own churn (empty "igp table" on all BGP channels, since this RR never resolves next hops), which removed most next-hop re-evaluation. The main thread is still saturated in msl_cleanup. Is this a known limitation of the mslab cleanup? Is there a way to tune it, or a fix we could test? We can run debug builds or collect more perf data. Disclosure: I used an LLM (Claude) to help analyse the perf and core data. The numbers above are from our production system. Best regards, Marcelo Balbinot