I tried bird (1.0.11, OSPF) and i found several bugs or strange behavior: 1) Bird is generating strange warnings: 'bird: nl_parse_link: Malformed message received' 'bird: Ignoring bogus route 0.0.0.0/32 received via ospf1' (on some routers several messages per minute, on other routers one message per several minutes) 2) Bird is complaining about /31 network prefixes, although these are valid according to RFC 3021 3) According to examples in the documentation, interface mask like "eth0", "eth1" should be valid, but this doesn't work for me in intercase section: interface "eth0", "eth1" { ... } I didn't find grammar for interface masks in documentation. 4) Sometimes the link between two routers hangs. Bird reports for example ptp/exstart at one side and ptp/exchange at the other side. Or full/ptp at one side and nothing at the other side. 5) When i change OSPF cost of an interface (in the interface section of the config file) and use 'configure' command, the costs are not updated. I have to restart the daemon. 6) If i have a route that aims to non-present IP range (for example route 192.168.37.48/29 via 192.168.37.96; when there is no local route for 192.168.37.96), then i start bird and then i add IP address to some interface, the route does not appear, not even after 'configure' command. I have to restart the daemon. -- Elen sila lumenn' omentielvo Ondrej 'SanTiago' Zajicek (email: santiago@crfreenet.org) OpenPGP encrypted e-mails preferred (KeyID 0x11DEADC3, wwwkeys.pgp.net) "To err is human -- to blame it on a computer is even more so."