I understand I can`t use lladdress. thank you.
in birdc6. but I think correct lladress format is "fe80::[EUI64]". what is happened ? can I change to lladdresses I want to use?
I will check this.
this is terminal messages. # ifconfig re0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500 options=9b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM> ether 54:52:00:2b:e1:b5 inet6 fe80::5652:ff:fe2b:e1b5%re0 prefixlen 64 scopeid 0x1 inet ******** 0x******** broadcast ******** inet6 *************** prefixlen 64 media: Ethernet autoselect (100baseTX <full-duplex>) status: active lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384 options=3<RXCSUM,TXCSUM> inet 127.0.0.1 netmask 0xff000000 inet6 ::1 prefixlen 128 inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2 tun0: flags=8051<UP,POINTOPOINT,RUNNING,MULTICAST> metric 0 mtu 1500 inet6 fe80::5652:ff:fe2b:e1b5%tun0 prefixlen 64 scopeid 0x3 Opened by PID 666 tap0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1280 ether 00:bd:ac:c3:07:00 inet6 fe80::7:0:fc32:1%tap0 prefixlen 64 scopeid 0x4 Opened by PID 2565 # birdc6 BIRD 1.2.1 ready. bird> show interfaces re0TR up (index=1) MultiAccess Broadcast Multicast AdminUp LinkUp MTU=1500 ***************/64 (Primary, scope univ) fe80:1::5652:ff:fe2b:e1b5/64 (Unselected, scope link) lo0 up (index=2) MultiAccess AdminUp LinkUp Loopback Ignored MTU=16384 ::1/128 (Primary, broadcast ::1, scope host) fe80:2::1/64 (Unselected, scope link) tun0 up (index=3) PtP Multicast AdminUp LinkUp MTU=1500 fe80:3::5652:ff:fe2b:e1b5/64 (Primary, scope link) tap0 up (index=4) MultiAccess Broadcast Multicast AdminUp LinkUp MTU=1280 fe80:4::7:0:fc32:1/64 (Primary, scope link)