How to export prefixes configured on loopback via OSPF

11 Jun 2015

      Hi,

How to export prefixes configured on loobback interfaces through OSPF.
working fine with BGP.

following is the configuration that I have tried.
But 192.168.1x.1 are not shown in neighbor's route table.

Thanks in advance.

*ifconfig output :*

lo:11     Link encap:Local Loopback
          inet addr:192.168.11.1  Mask:255.255.255.0
          UP LOOPBACK RUNNING  MTU:65536  Metric:1

lo:12     Link encap:Local Loopback
          inet addr:192.168.12.1  Mask:255.255.255.0
          UP LOOPBACK RUNNING  MTU:65536  Metric:1

*bird.conf*

router id 1.1.1.1;

protocol direct {
        interface "eth1","eth2","lo*";
}

protocol kernel {
        persist;
        scan time 20;
        export all;
}

protocol device {
        scan time 10;
}

protocol ospf R1 {
        tick 2;
        rfc1583compat yes;
        area 0.0.0.0 {
                stub no;
                interface "eth1","eth2" {
                        hello 9;
                        retransmit 6;
                        cost 10;
                        transmit delay 5;
                        dead count 5;
                        wait 50;
                        type broadcast;
                        authentication simple;
                        password "admin";
                };
        };
}

Thanks,
Madhuri