On Wed, Dec 19, 2012 at 7:52 PM, Scott <scttlists@gmail.com> wrote:
Hi List,
Seeing the message of Jeff yesterday and the fact I have been trying to get bird to work for a few days now I am pretty sure I need help from soneone setting up bird.
We are basically setting up anycast with a few servers at three locations. The servers will need to speak OSPF to a Juniper router which then redistributes the routes accordingly to the internet. We would like to use bird(6) to do this for a few ips setup at the loopback interface (both IPv4 and IPv6).
I managed to get quagga ospfd working just fine, ospf6d not unfortunately. Figured switching to bird would help but I can't get IPv4 ospf in bird working either. I read the manual of bird a few times, top to bottom, googled around but didn't got it to work.
The servers are running CentOS 6.3, I have compiled bird & bird6 from source. What i need done is a full config for bird & bird6, I tried almost every setting so I think it is best if someone just creates a config from scratch for us. The setup is quite simple honestly, the routers are running ospf and ospfv3. IPs are assigned to the interfaces and loopback. We don't need ospf authentication but do need the bird config/process secured, logging to syslog and just some prefix filtering on what goes out over OSPF.
I have no problem paying for it. Hopefully somebody can help me out here.
Thanks a lot!
Scott
I assume that ospf is not very familiar for you so I give tip what can save mutch time. You need use same hello and dead timer in all devices in same L2. There is our config for our anycast dns server. With that config we use /32 mask in anycast ip as extra ip in server main interface. And in some cases you need also ip_forward to set 1. This sample conf is not wery strict (you can soot yo your leg if you have static routes or if that dns server is not dedicated for that purpose) but anyway it works ;) log "/var/log/bird.log" all; #this is very verbose so you maybe want something else router id 11.22.33.44; # fix this to uniq ip formatted id protocol kernel { persist; # Don't remove routes on bird shutdown scan time 20; # Scan kernel routing table every 20 seconds import none; # Default is import all but we trus our default route export all; # Default is export none but we want announce our interface ip } # This pseudo-protocol watches all interface up/down events. protocol device { scan time 10; # Scan interfaces every 10 seconds } protocol static { } protocol ospf ownospf { debug { states, events }; tick 2; rfc1583compat yes; export filter { accept; }; area 0.0.0.0 { interface "eth0" { hello 1; dead 10; }; }; }; -- F-Solutions Oy Tapio Haapala PL7, 90571 Oulu GSM 0400 998371 Skype burner- IRC Burner@ircnet