Hello. I want to be able to reload bird's configuration so it will not change current protocol's state. For example if I run bird with some protocols and then disable one of them from the console and at finally I run "configure" of "configure soft" to reload a configuration (new filters for example) - I get that protocol restarted too: bird> show protocols name proto table state since info device1 Device master up 2017-09-09 static1 Static master up 18:07:29 bird> disable static1 static1: disabled bird> show protocols name proto table state since info device1 Device master up 2017-09-09 static1 Static master down 18:10:01 bird> configure soft Reading configuration from /etc/bird.conf Reconfigured bird> show protocols name proto table state since info device1 Device master up 2017-09-09 static1 Static master up 18:10:10 bird> But I want protocol to still be disabled in this case. Because I have disabled it manually and want it to be started manually. Is there a way of reloading configuration, keeping manual state of protocols? I have already tried documentation and Google, but with no luck.