Hello, I’m running BIRD 1.4.5 on an IXP with this setup : "Route server with community based filtering and multiple RIBs" https://gitlab.labs.nic.cz/labs/bird/wikis/Route_server_with_community_based... I have noticed a strange behaviour of the "show route" command whenever I specify “table master” or not. (IP/AS have been anonymised in order to follow the example above) : root@rs2-th2:~# birdc "show route all 12.34.0.0/16 protocol R111x1" BIRD 1.4.5 ready. 12.34.0.0/16 via 10.0.0.11 on eth1 [R111x1 2015-02-16 10:43:59] * (100) [AS111i] Type: BGP unicast univ BGP.origin: IGP BGP.as_path: 111 BGP.next_hop: 10.0.0.11 BGP.med: 0 BGP.local_pref: 100 BGP.community: (0,51706) root@rs2-th2:~# birdc "show route table master all 12.34.0.0/16 protocol R111x1" BIRD 1.4.5 ready. 12.34.0.0/16 via 10.0.0.11 on eth1 [R111x1 2015-02-17 11:05:45] * (100) [AS111i] Type: BGP unicast univ BGP.origin: IGP BGP.as_path: 111 BGP.next_hop: 10.0.0.11 BGP.med: 0 BGP.local_pref: 100 BGP.community: (51706,64650) (51706,64602) (0,51706) When explicitly specifying “table master” I see communities added from filter “bgp_in_AS111”. When not specifying any table I see route from T111 (the table declared in "protocol bgp R111x1"). Actually I was expecting to have same output on both commands, as it explained in documentation : "If you want to see routes that where accepted from this router to the master routing table then type: bird> show route protocol R222x1" Does any body also noticed this behaviour? Regards, -- Arnaud Fenioux Network Engineer - FranceIX