Hello. I have some sites linked via wiregard tunnels, and exchanging route information with OSPF, using bird (mostly) One of my routers is running bird 2.0.7, while others runs 1.6.6 (due to different distributions) All OSPF v2 is running well, with configs like : interface "wg-*" { type ptp; }; OSPFv3 runs fine between bird 1.6 routers, but it does not with the bird 2.0 one. Here is its config : protocol ospf v3 ospfv3 { ipv6 {}; area 0 { interface "eth*" { stub; }; interface "wg*" { type ptp; cost 20; stub no; }; }; } Alas, it does not send any Hello packets on links. The remote routers do send their hellos, but they are ignored. It looks like bird put these interfaces in stub mode : linux3:/etc# birdc show ospf in ospfv3 BIRD 2.0.7 ready. ospfv3: Interface eth0 (IID 0) Type: broadcast Area: 0.0.0.0 (0) State: Waiting (stub) Priority: 1 Cost: 10 ECMP weight: 1 Hello timer: 10 Wait timer: 40 Dead timer: 40 Retransmit timer: 5 Designated router (ID): 0.0.0.0 Designated router (IP): :: Backup designated router (ID): 0.0.0.0 Backup designated router (IP): :: Interface wg4b (IID 0) Type: ptp Area: 0.0.0.0 (0) State: PtP (stub) Priority: 1 Cost: 20 ECMP weight: 1 Hello timer: 10 Wait timer: 40 Dead timer: 40 Retransmit timer: 5 Interface wg4a (IID 0) Type: ptp Area: 0.0.0.0 (0) State: PtP (stub) Priority: 1 Cost: 20 ECMP weight: 1 Hello timer: 10 Wait timer: 40 Dead timer: 40 Retransmit timer: 5 With OSPF v2, it does not : linux3:/etc# birdc show ospf in ospfv2 BIRD 2.0.7 ready. ospfv2: Interface wg4b (peer 172.16.101.21) Type: ptp Area: 0.0.0.0 (0) State: PtP Priority: 1 Cost: 200 ECMP weight: 1 Hello timer: 10 Wait timer: 40 Dead timer: 40 Retransmit timer: 5 Interface wg4a (peer 172.16.101.17) Type: ptp Area: 0.0.0.0 (0) State: PtP Priority: 1 Cost: 200 ECMP weight: 1 Hello timer: 10 Wait timer: 40 Dead timer: 40 Retransmit timer: 5 These interfaces have some IPv6 addresses, as it's needed for bird communications : 7: wg4b: <POINTOPOINT,NOARP,UP,LOWER_UP> mtu 1420 state UNKNOWN qlen 1000 inet6 fe80::3/128 scope link valid_lft forever preferred_lft forever 8: wg4a: <POINTOPOINT,NOARP,UP,LOWER_UP> mtu 1420 state UNKNOWN qlen 1000 inet6 fe80::3/128 scope link valid_lft forever preferred_lft forever Do you have tips on how to make them work ? Thanks, -- Bastien