Hi, I have many peer running, and up state remain without changing (in case if bird is dieing or restarted by init ) even those should be seen as flapped right. ? This looks more of config getting reloaded which is causing the the stateless peer disable to get activated . -Roobesh G M Get Outlook for Android<https://aka.ms/ghei36> From: Alexander Zubkov Sent: Tuesday, 22 January, 12:15 PM Subject: Re: Bird peer disabled via control socket is automatically getting enabled To: Mohandass, Roobesh Cc: bird-users@network.cz This email originated from outside of the organization. Do not click links or open attachments unless you recognize the sender and know the content is safe. Hi, I have not experienced such problems. I had disabled peers for a long time which remained enabled in the configuration file. So you should have something reloading configuration. Or may be your bird dies for some reason and is restarted by init system etc. On Tue, Jan 22, 2019 at 6:53 AM Mohandass, Roobesh wrote: > > Hi Team, > > > > We are using BIRD version 1.6.3 in ubuntu 18.04 LTS kernel 4.15.0-42-generic, use case below. > > > > I have disabled few bgp peer using ‘birdc disable ’ and after an hour or so, I just seen the peers are enabled back automatically, but I have not run ‘birdc enable ’. > > > > So thinking, was there anything that is reloading the bird configure at specific interval automatically or enabling the disabled peer automatically ? I have not configured anything related to below ones to be sure, > > configure [soft] ["config file"] [timeout [num]] > > > > Side Note: we are aware of commenting the peers which we are thinking to disable and then reload the config to make it always in disabled state. But just would like to check, why when we disable the peer from bird control socket , we observe this behavior. > > > > Thanks for your attention on this message. > > > > -Roobesh G M > > > >