Re: OSPF export filter

3 Dec 2015


      Hello,
concretely "birdc show route export server1" show what ?
Another good hint could be "birdc show ospf state", where you can see 
ospf informations about whole infrastructure which ospf knows.
Vilem

On 12/03/2015 01:50 AM, Anton Kiryushkin wrote:
...
Hello.
I trying to use bird for export ospf route for Cisco Nexus with next 
config:
router id 10.34.23.1;
filter export_OSPF {
        if net = 77.71.22.23/32 <http://77.71.22.23/32> then {
                ospf_metric1 = 20;
                ospf_metric2 = 20;
                print "net accepted:", net;
                accept;
        }
        if net = 77.71.22.24/32 <http://77.71.22.24/32> then {
                ospf_metric1 = 10;
                ospf_metric2 = 10;
                print "net accepted:", net;
                accept;
        }
        reject;
}
protocol ospf server1 {
        export filter export_OSPF;
        #debug all;
        rfc1583compat yes;
        tick 2;
        area 0.0.0.0 {
                stub no;
                interface "bond0" {
                        dead 10;
                        neighbors {
                                10.0.16.1;
                        };
                        type pointopoint;
                        authentication none;
                };
                interface "lo*" {
                        stub yes;
                        cost 10;
                        priority 200;
                };
                interface "dummy0" {
                        stub yes;
                        cost 15;
                        priority 100;
                };
        };
}
But in birdc I didn't see any metrics. I have two server with same 
config and same addresses on interfaces lo and dummy0 with different 
priorities.
Could you help me with export filter?
-- 
Best regards,
Anton Kiryushkin
-- 


S pozdravem Vilem Kebrt
email: viker@viker.cz
tel: +420 604 550 132